Schaffer XV Arrow Rest: Setup Steps and Tuning Tips for Archers
Learn how the Schaffer XV arrow rest works, how to set it up on your bow, and which tuning checks help your arrows fly true. A clear guide for new archers.
Updated November 2026
The Schaffer XV arrow rest is a containment-style rest that holds your arrow in place until release. This guide explains what the XV does, how to mount it, and how to tune it so your arrows fly straight. You will need basic hand tools, a bow square, and a field point or two to finish the job.
What the Schaffer XV Arrow Rest Does
A Schaffer XV is built around a flexible, shaped arm that sits in the arrow’s path and cradles the shaft on the way to the target. Unlike a drop-away rest, it stays in place during the shot, which many archers prefer for consistency. Because the arm stays under the shaft at all times, small changes in nock height or rest position can affect how the arrow leaves the bow. Setup and tuning matter more here than the mounting hardware itself.
Shopping for one? See our guide: Arrow Rest for Compound Bow: 6 Best Picks Compared (2026).
Step-by-Step Installation
Start by mounting the rest to the riser at the height recommended for your arrow and cam or limb setup. Work through these steps in order:
- Set the rest so the arrow sits level with the bow square when the arrow is nocked and at full draw.
- Tighten the mounting screws only enough to hold the rest firmly, then check that it does not wobble.
- Position the rest horizontally so the arrow’s centerline lines up with the center of the riser.
- Adjust the cushion or arm tension according to the manufacturer’s guidance so the arrow rests lightly on the arm.
- Re-check the bow square after each adjustment before you shoot.
Tuning the Schaffer XV for Straight Arrow Flight
Tuning turns a correctly mounted rest into a rest that gives clean arrow flight. Begin at a short distance, around 10 yards, and shoot paper or a bare shaft test to see how the arrow leaves the bow.
Paper Tuning Basics
Shoot an arrow through paper held about three feet in front of the target. A tear shaped like a fish tail or a keyhole usually means the rest or nock is out of line. Move the rest in small increments and shoot again until the tear shows a clean hole with minimal feather marks.
Bare Shaft Checks
Once paper tuning looks close, shoot a bare shaft alongside a fletched arrow at 15 to 20 yards. If the bare shaft lands to the side of the fletched arrow, the rest or the nock height needs another small adjustment.
Common Mistakes
- Overtightening the mounting screws, which can shift the rest after a few shots.
- Skipping the bow square check after each adjustment, leading to repeated errors.
- Changing the rest and the nock height at the same time, which makes it hard to tell what fixed the problem.
- Setting arm tension too firmly, which can cause the arrow to skip or drop off the rest.
- Tuning at long distance before the arrow flies cleanly at short range.
Recommended Gear
- A bow square helps you confirm the rest and arrow sit at the correct angle before every tuning session. View on Amazon
- Paper tuning tears are easier to read on a tuning frame, which holds the paper steady at a fixed distance. View on Amazon
- A set of field points lets you check arrow flight without the risk of fletching interference during bare shaft tests. View on Amazon
FAQ
Is the Schaffer XV good for beginners?
Many beginners find containment rests easier to keep consistent than drop-away styles because the arrow stays supported through the shot. Setup still takes patience, so expect some trial and error during tuning.
How often should I re-tune the rest?
Re-check tuning whenever you change arrows, string, nock height, or draw length, and after any major impact to the bow. A quick paper test at the start of each session helps catch drift early.
Can I use the Schaffer XV on a traditional bow?
Traditional bows usually use different rest styles, and fitting a containment rest to them depends on the riser and shelf design. Check the manufacturer’s compatibility notes before mounting.
Conclusion
A properly mounted Schaffer XV arrow rest, tuned with paper and bare shaft tests, will help your arrows leave the bow cleanly. Work in small adjustments, check your bow square after each change, and tune at short range first. Review the related guides on this site for deeper setup and tuning ideas.
Related reading
- Schaffer Archery Opposition Arrow Rest: Setup Steps and Tuning Tips
- Zero Effect Arrow Rest: How It Works and How to Set One Up
- Whisker Biscuit Arrow Rest Installation: A Step-by-Step Guide
- What Holds Arrows in Archery: Quivers, Arrow Rests and Holders Explained
- Vapor Trail Gen 7 Arrow Rest Review: Key Features Explained
- Vapor Trail Arrow Rest Review: Pros and Cons
Ready to choose one?
