We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

Bow Peep Sight with Lens: How to Install and Aim One (Step by Step)

Learn how a bow peep sight with lens works, how to install and align it, and how to set your anchor point for tighter, more consistent groups.

Updated November 2026

A bow peep sight with lens is a small aperture mounted in your bowstring that you look through to line up your anchor point with the target. Once it is installed and aligned, the peep gives you the same sight picture on every shot, which tightens your groups. This guide covers choosing the right peep, installing and centering it, and checking your anchor.

What a Peep Sight with Lens Does

The peep is a ring or tube tied into the string, and the lens sits inside it. The lens is usually ground to magnify slightly, so your eye sees the front sight and target more clearly through the opening. Because your eye always sits at the same point relative to the string, your aim stays repeatable from shot to shot.

Shopping for one? See our guide: Bow Sights with Rangefinder: 5 Best Picks Compared (2026).

Choosing the Right Peep

Match the peep’s opening size to your eye and your sight. Smaller openings sharpen the picture but demand more precise alignment, while larger openings are more forgiving in low light. Make sure the lens is clean and free of scratches, and confirm the peep fits your string’s diameter so it sits square without twisting.

Installing and Aligning the Peep

  1. Lay the bow on a flat surface and check the string serving, where the peep will sit. Mark the spot about 1/8 inch above the nock point.
  2. Tie or press the peep into the string at the mark. Keep the lens facing you, and make sure the peep is vertical with the string running through its center.
  3. Brace the bow and draw to your normal anchor. Look through the peep: the bottom of the peep should be level, with the string centered in the frame.
  4. If the peep tilts, loosen the serving and rotate it slowly until the frame sits level. Re-serve or secure the peep so it cannot slip.
  5. Draw again and confirm your anchor. Repeat the check several times before shooting arrows.

Setting Your Anchor Point

Your anchor should be the same every time. Draw to a consistent spot on your face or jaw, and keep your nose and string hand in contact with the same landmarks. If the peep sits too high or low for your anchor, move it up or down a few millimeters at a time and test again.

Common Mistakes

  • Installing the peep at an angle, which shifts your sight picture off center.
  • Changing your anchor between shots, which makes the peep useless for consistency.
  • Using a dirty or scratched lens, which blurs the target and hides small alignment errors.
  • Failing to secure the peep, so it slides after a few weeks of shooting.
  • Choosing an opening that is too small for your light conditions.
  • A bow peep sight kit with a lens: helps you keep a consistent, magnified sight picture. View on Amazon
  • Serving thread for archery bowstrings: lets you secure the peep firmly at the right height. View on Amazon

FAQ

How high should a peep sight sit on the string?

Most archers set it about 1/8 inch above the nock point, then adjust it for their anchor. Always confirm by looking through the peep at full draw.

Does the lens magnify the target?

Many peep lenses are ground with slight magnification, which sharpens the front sight and target. Exact effects depend on the lens, so check the product specifications.

Can I install a peep without special tools?

Yes, a basic serving tool and thread are enough for most setups. If you are unsure about string work, ask a qualified bow technician to install it.

Conclusion

A bow peep sight with lens gives you a repeatable sight picture once it is level, centered and tied to a consistent anchor. Take your time with alignment, and recheck the peep after the first few sessions. For more on sight setup, see Garmin Rangefinder Bow Sight: Setup, Calibration and Use Guide.

Ethan Brooks

About Ethan Brooks

Ethan Brooks is part of our editorial team and reviews and edits our target archery guides, checking product details against manufacturer specifications and owner feedback.

About the author

Ethan Brooks
Ethan Brooks

Ethan Brooks writes reviews and buying guides for Archery Society.