Why Does My Bow Shooting Low Move Sight Pin Point Down? Causes and Fixes
Bow shooting low move sight? Learn the common causes, how to adjust your sight pins and anchor, and steps to get your arrows back on target.
Updated November 2026
If your arrows keep landing below your aim point, the sight is usually not the problem. A bow shooting low move sight issue most often comes from a change in your anchor, release, or grip, or from a sight that has drifted out of alignment. To fix it, check your form first, then re-sight at a known distance and move the pin in the direction of your arrows.
Why Your Arrows Hit Low
When arrows consistently land low, the sight is simply telling you the truth about where the bow is pointed at full draw. Three things cause most low groups:
Shopping for one? See our guide: Bow Sights with Rangefinder: 5 Best Picks Compared (2026).
- Anchor point drift. If your anchor sits lower on your face or jaw than it did during setup, your eye and sight line shift, and the pin sits too high relative to where you actually aim.
- Dropping the bow arm or collapsing the drawing elbow. A bow arm that sags or a rotating shoulder changes the bow’s angle at release.
- Anticipation. Flinching or pulling the string early can send the arrow low as the bow moves before the arrow leaves.
Sight Adjustments That Correct Low Impacts
Once your form is consistent, you can move the sight. Most sights are adjusted in one of two ways: by moving the pin guard or pin housing up or down, or by changing the sight’s vertical position on the riser. Manufacturers generally specify the adjustment range for each model, so check your manual before turning any screws.
Shoot a group of three to five arrows at a fixed distance, such as 20 yards. If the group sits a few inches below your aim, move the pin slightly toward the direction of the arrows. Shoot another group, then repeat until the arrows land where you aim. Make small changes, because a large move can overcorrect and create the opposite problem.
Practical Steps to Fix a Low Group
- Confirm your anchor point is the same on every shot. Mark it with a fixed reference, such as your nose or the corner of your mouth.
- Check that your sight is mounted firmly and that the pin housing is not loose.
- Shoot at 10 to 20 yards and record where the arrows land relative to your aim.
- Adjust the pin in small increments, then re-test before changing anything else.
- If the group stays low after adjustment, recheck your draw length, bow tune, and release.
What We’d Use
A stable, well-made sight with fine vertical adjustment makes these corrections easier to repeat. Look for a product type that matches your bow, such as a single-pin or multi-pin sight. View on Amazon is a commonly cited option with pin housing adjustments. A basic bow sight level, sold as a bubble or magnetic level, helps you confirm the bow is held upright during aiming. View on Amazon is useful for checking your setup.
FAQ
Should I always move the pin when my arrows hit low?
No. First check your anchor, bow arm, and release. If your form changed, the pin may be correct and your technique needs work.
How far should I move the sight pin?
Move it in small steps. Many archers adjust a fraction of an inch at a time and re-test at the same distance before making another change.
What if my bow shooting low move sight problem continues after adjusting?
Review the basics in Bow Sight Set Up: A Step-by-Step Guide for Accurate Shooting, then check the bow’s tune. If problems persist, consult a certified archery coach or a pro shop for a hands-on assessment.
Related reading
- Hind Sight Bow Sight: How to Set Up and Use One for Target Shooting
- Xero A1i Pro Bow Sight: Setup, Pin Tuning and Tips for New Archers
- What Is the CBE Tactic Hybrid 1-Pin Bow Sight and Is It Right for You?
- What Is a Sight Master Bow Sight and How Do You Set One Up?
- What Is a Dead Ringer Bow Sight and How Do You Use One?
Ready to choose one?
