We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

Black Leather Back Quiver: A Step-by-Step Guide to Choosing and Setting One Up

Learn how to choose, fit and set up a black leather back quiver for target archery, with sizing tips, carry positions and care steps for new archers.

Updated November 2026

A black leather back quiver is a traditional way to carry arrows on your back, keeping them within easy reach while you shoot. This guide walks you through choosing the right size, fitting the quiver to your body, setting up the arrow draw and caring for the leather so it lasts. By the end, you will know how to set up a black leather back quiver that stays comfortable through a full session on the range.

Choose the Right Size and Capacity

Start by counting the arrows you shoot in a typical end. Most target archers shoot three to six arrows per end, so a quiver that holds at least six arrows gives you room to spare. Measure the arrows’ nock-to-tip length, and make sure the quiver’s inside depth is slightly longer than your arrows. Arrows that stick out too far get bumped, and arrows that sit too deep are hard to grab quickly.

Shopping for one? See our guide: Bear Archery Traditional Back Quiver Review (2026).

Check the width of the quiver body as well. A wider opening is easier to grab from, but it also lets arrows rattle, so look for a snug fit around the shafts.

Fit the Quiver to Your Body

Put the quiver on before your first end and adjust the straps while you are standing in your shooting stance. The quiver should sit mid-back, with the top of the arrows roughly level with or slightly above your shoulder line. If the arrows are too high, they will catch on your bow arm or bowstring. If they are too low, you will have to reach awkwardly behind you.

Tighten the waist strap so the quiver does not swing when you walk. The body strap should keep the quiver close to your spine without pressing into your shoulder blades. Recheck the fit after you have shot a few ends, since leather stretches slightly with use.

Set Up Your Draw and Shooting Routine

  1. Stand at the shooting line and fasten the waist strap until the quiver stays put.
  2. Reach back with your draw hand and practice pulling a single arrow out. Repeat three or four times until the motion feels smooth.
  3. Nock the arrow, keeping the fletching clear of the quiver opening so it does not snag.
  4. Return the arrow to the quiver after each shot, pushing it in gently so the nock seats without bending the shaft.

Many archers find that keeping the quiver’s opening facing slightly outward makes arrows easier to grab. Experiment with the angle until your draw hand moves without looking.

Care for Your Leather Quiver

Wipe the leather with a dry cloth after each session, especially if the range is damp or dusty. Once or twice a season, apply a leather conditioner made for tooled or dyed leather, and test it on a hidden spot first, since some products can darken black leather. Avoid storing the quiver in a hot car or near a heater, which can dry out and crack the material.

Check the stitching and rivets each month. Loose stitching can let arrows slip out during a shot, so tighten or repair it before it fails.

Common Mistakes and Tips

  • Setting the quiver too high, which causes arrows to hit your bow arm or string.
  • Letting the quiver swing when you walk, which tires your back and scuffs the leather.
  • Pulling arrows out at an angle, which can snag fletching on the rim.
  • Storing arrows loose in a damp quiver, which can warm and soften the leather over time.
  • Skipping the post-session wipe-down, which lets dirt work into the seams.

A leather conditioner made for dyed or tooled leather helps keep the black finish supple without making it sticky. View on Amazon

A soft microfiber cloth is useful for quick wipe-downs after the range, since it picks up dust without scratching the surface. View on Amazon

A quiver belt or waist strap extension can help you fine-tune the fit if your body shape differs from the standard sizing. View on Amazon

FAQ

How many arrows should a black leather back quiver hold?

Most target archers choose a quiver that holds six or more arrows, which covers a standard three- to six-arrow end with some spares. Choose a larger capacity if you shoot longer ends or carry extra arrows.

Can I use a black leather back quiver for field archery?

Yes, though field archers often prefer a quiver that holds arrows more securely while walking and bending. Check that the straps keep the quiver steady on uneven ground.

How often should I condition the leather?

Conditioning once or twice a season is usually enough for regular use. Dry or cracked leather may need more frequent care, and you should always test a product on a hidden area first.

Conclusion

A well-fitted black leather back quiver keeps arrows organized and within reach, letting you focus on your form. Set the height and straps correctly, practice your draw, and care for the leather after each session. With these steps, your quiver will stay comfortable and reliable for seasons of shooting.

Lauren Holland

About Lauren Holland

Lauren Holland is part of our editorial team and reviews and edits our target archery guides, checking product details against manufacturer specifications and owner feedback.

About the author

Lauren Holland
Lauren Holland

Lauren Holland writes reviews and buying guides for Archery Society.