We research and compare products using published specifications, features and owner feedback. When you buy through our links, we may earn a commission. As an Amazon Associate I earn from qualifying purchases. Learn more›

Back Quiver for Arrows: A Step-by-Step Guide to Choosing and Wearing One

Learn how to choose, fit and wear a back quiver for arrows, with steps for sizing, strap setup and arrow access so your shooting stays smooth.

Updated November 2026

A back quiver for arrows is a tube or pouch worn across the upper back that holds your arrows point-down and ready to draw. This guide walks you through choosing the right style, fitting it to your body and setting it so you can grab an arrow quickly without snagging your bowstring. Most new archers can get a comfortable setup in under an hour.

Choose the Right Style for Your Shooting

Back quivers come in a few main designs. Target archers often pick a flat, fixed-strap model that holds four to six arrows. Traditional shooters frequently prefer a leather back quiver with a tube body and a shoulder strap. Field archers sometimes choose a shorter quiver so the arrows sit lower and clear the string more easily. Check whether the quiver holds your arrow length and fletching size before you buy.

Shopping for one? See our guide: Bear Archery Traditional Back Quiver Review (2026).

Fit and Adjust the Quiver to Your Body

  1. Put the quiver on as you would a backpack and tighten the shoulder straps until the body sits against your upper back.
  2. Set the quiver height so the arrow nocks sit roughly at shoulder level or slightly above when you stand relaxed.
  3. Angle the opening toward your dominant hand. Right-handed archers usually tilt it slightly to the right so the draw hand reaches in naturally.
  4. Insert an arrow and draw your bow slowly. Make sure the fletching does not catch on your clothing or your bow arm.

Set Up Arrow Access and Retention

Arrows should slide out with one smooth motion and stay put when you walk, bend or raise your bow. If the arrows rattle or fall out, tighten the retention insert or check whether the quiver’s tension adjustment is set correctly. Many manufacturers specify a snug fit for the arrow diameter, so test with two or three arrows before you commit to a setting.

Check Clearance and Movement

Stand at full draw and reach back for an arrow. Your bow string should clear the quiver top, and your elbow should not hit the tube. If the quiver rubs your back or pulls on your shirt, lower it slightly or change the strap length.

Tools and Setup Checklist

  • Arrows cut to your draw length and matched in weight
  • Adjustable shoulder straps or a back plate
  • A tape measure for checking quiver height and arrow length
  • Replacement retention inserts or foam liners if the fit feels loose

Common Mistakes

  • Setting the quiver too high, which makes arrows hard to grab at full draw.
  • Ignoring arrow length and buying a quiver that is too short for your shafts.
  • Over-tightening the straps, which causes back discomfort after a long session.
  • Skipping a test draw, which can reveal string clearance problems early.
  • Leaving arrows in the quiver when walking to and from the target, which can cause injury if the points shift.
  • Adjustable back quivers: Models with height and angle adjustment let you fine-tune fit for different bows and body sizes. View on Amazon
  • Replacement retention inserts: Foam or felt liners keep arrows secure if the original fit loosens over time. View on Amazon

FAQ

How high should a back quiver sit?

Most archers set the arrow nocks near shoulder level or slightly above when standing relaxed. This keeps the arrows easy to reach at full draw without interfering with your bow arm.

Can I use a back quiver for any arrow length?

Only if the quiver’s tube or pocket is long enough to hold your arrows fully. Check the arrow length against the quiver specifications before you buy.

Is a back quiver uncomfortable for long sessions?

It should not be if the straps are adjusted correctly and the quiver sits flat against your back. If you feel ongoing pain, adjust the setup or consult a qualified professional such as a physical therapist.

Conclusion

A well-fitted back quiver keeps your arrows secure, accessible and out of your way. Choose a style that matches your shooting, set the height and angle carefully, and test your draw before you shoot for score. With these steps, your setup should feel natural after a few sessions.

Lauren Holland

About Lauren Holland

Lauren Holland is part of our editorial team and reviews and edits our target archery guides, checking product details against manufacturer specifications and owner feedback.

About the author

Lauren Holland
Lauren Holland

Lauren Holland writes reviews and buying guides for Archery Society.